14
Slide Time Time between advancing to the next photo.
Slide Mode Many different modes can be used, for dissolving to the next photo, dened
by a number. Also, it is possible to select Random order to view the photos.
Movie Congure For Subtitle use in the movie player, setup the features here.
Subtitle Specic Select either normal, big or small for Subtitle size.
Subtitle BG Select the preferred colour of the Subtitle Background.
Subtitle FontColor Select the preferred colour of the Subtitle characters.
PVR Congure For this option to work, you must have a USB device connected.
Record Device If your USB device should have more than 1 partition, select the one to use.
Timeshift Size Select the amount of free space, to be assigned to the Timeshift function.
Default is 1GB, which would account for around 1 hour of video, depending
on the video format and resolution.
Note: Below this setting information is shown about the current partition or
device.
Format The use of a USB Hard Disk Drive, already formatted in a PC with FAT32 or
NTFS is recommended.
WARNING: The format function will delete all data and information from your USB
device or selected partition. Manufacturer will not take any responsibility
for damaged or lost data on the USB device.
If you have multiple partitions on your storage device, select the partition you would like to format
and press OK to continue. A conrmation banner will now be displayed. Press OK to start formatting
(or EXIT to cancel it). The format procedure will take some time, depending on the size of the used
storage device. At the end of the process, the “Formatting is complete” message will appear. Press
EXIT twice to exit the menu.
Network Apps Note: These simple network applications will only work if you have set up
the Network Setting in the System menu and have a working connection to
the internet. (Status: Internet)
Follow the On-Screen button suggestions to navigate through and edit the Apps.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try
to open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem Possible cause What to do
The LED/standby
indicator and LED
display (if available on
your receiver) are not
switching on.
The power cable or power adapter
is unplugged.
Check that the power cable or
power adapter is plugged to the
wall outlet.
If your receiver has a main power
switch: The main power switch on
the rear panel is set to OFF.
Switch the main power on.
The electrical outlet may be
damaged.
Check with another device if the
electrical outlet is supplied.
To Next Page
Loading...
