THOMSON VTH6050F - Using the Remote Control

10
Use
Using the remote control
J
Your remote control enables you to operate the video
recorder or television set without leaving your seat. All
you have to do is to press either key VCR for the video
recorder or TV for the television. For the television set,
you'll have to programme the remote control as
explained below.
Other makes: see page 21
The main functions of your remote control can be found on the VCR frontside.
J
to
and
To navigate through the menus
and validate with OK.
Controlling the television set
Press key VCR to control your video
recorder.
To exit a menu at any time.
1
Press key TV to control your television set.
To switch your television on* or off.
To zoom
in / zoom+
To zoom
out / zoom-
The last two functions are
only available on television
sets of our make.
These keys have the same functions as the
corresponding keys of the remote control of
your television set (when the latter is of our
make).
to
To switch over to another channel.
To adjust the sound volume.
Mute.
To switch the television set on*
or to select another channel.
To select a SCART socket and watch the
pictures of the set connected to this socket.
*
key(s) for switching the television on and off depending on the model.
2
18
17
19
23
16
3
11
13
4
15
19
23
24
25
26
20
21
22
27
28
29
3
4
5
6
7
14
15
9
8
13
To switch your video recorder on and off.
To select the decoder function.
To call up the SHOWVIEW menu.
To display the information screen.
inactive.
To call up the SUMMARY menu.
18
To switch over to another channel.
Rewind.
Play.
Fast forward.
To mark an index.
Counter reset.
To double the recording time with LP.
Stop.
Pause / Still image.
Recording.
To select a channel.
For 2-digit channels, first press 0/--
(0, 1, 2 for Pr12).
To select the units connected to the
Audio/Video sockets (AV1, AV2, AV3, AV4)
Controlling the video recorder
Programming the remote control with the TV code
1 Press key TV on the remote control.
2 Hold down key MENU (15) and enter the three-digit code corresponding to the make of
your television set (see the code table below).
3 Release key MENU (15) and try to control the television set.
J
The codes depend on the television model. Should a given code not work, try another. When you
replace the batteries of the remote control, you have to programme it again
J
Your remote control can be used to control some functions of most television sets. To this end, you
must programme it with one of the codes provided in the table below or on page 21 of this user
manual.
BRANDT . . . . . . . . . . .001-000-010-020
FERGUSON . .001-003-004-000-010-020
NORDMENDE . . . . . . .001-010-020-000
SABA . . . . . . .001-000-005-010-019-020
TELEFUNKEN . . .001-002-000-010-020
THOMSON . . . . . .001-000-002-010-020
Brand of your TV set Brand code
r9_2EN01 25/01/00 10:36 Page 10