THOMSON VTH6050F - Programming a Recording

14
Use
Programming a recording
J
You can programme a recording with the ShowView
codes indicated in your TV magazine or by means of
timer programming if you don't know these codes. Your
video recorder has 8 programming memories. Thus,
you'll be able to programme 8 recording over a 1-year
period.
ShowView codes
With the ShowView codes
Without the ShowView codes
With a tape loaded, on the display confirms your successful programming.
16.2516.25
FUNNY TIMESFUNNY TIMES
filmfilm
Drama-comedy
5862458624
TUESDAY
1 Call up the SHOWVIEW menu with key PROG. (5).
2
Enter the code of the programme with the number keys (19).
3 Confirm with OK (10).
ð The
TIMER menu comes up.
ð The Stop line is selected.
ð You can complete your programming by selecting the following options: recording
triggered by VPS or PDC signals, daily repeated recording of a television serial, long play.
J
When programming for the first time, the cursor positions itself on Prog. number; confirm or enter
the desired programme number. For a channel received via the satellite / cable decoder,
select SA---.
4a Validate your programming by pressing OK (10),
4b or leave the
TIMER menu with key EXIT (14).
5 Switch the video recorder on standby with key
BB
(3).
ð The indication appears on the display of your video recorder to tell you that your
programming was successful.
J
If you don't know the ShowView code of the telecast you wish to record, you'll have to use
the
TIMER menu.
1 Display the SUMMARY menu with key MENU (15).
2
Select Timer with key
WW
(12).
3 Confirm with OK (10).
ð The
TIMER menu comes up.
4 Make use of the number keys (19) to enter the channel number or select the
corresponding AV socket if you want to record a satellite and / or encoded programme.
5 Type in the following information by selecting the corresponding line with the
key
WW
(12) :
• start time of the programme,
• end time of the programme,
• the date, if the recording is not to take place on the same day.
ð You can complete your programming by selecting the following options: recording
triggered by VPS or PDC signals, daily repeated recording of a television serial, long play.
6 Switch the video recorder on standby with key
BB
(3).
ð The indication appears on the display of your video recorder to tell you that your
programming was successful.
J
A great number of satellite receivers, among them all digital models, need to be left on to make sure
that they properly perform timer-programmed recordings.
J
Load a tape and position it to the desired section with keys REW., FWD., STOP, PLAY
(24, 26, 27, 25).
r9_2EN01 25/01/00 10:36 Page 14