THORENS TD-150 - II. Unpacking of the TD-150 and TD-150 A turntables

Il. Unpacking of the TD-150 and TD-150 A turntables
1 Fig. 3. Additional packing material for
Ea]
e
TD-150
A
and
TO-150
turntables.
Proceed in the same way as for Model TD-150 AB, points 1 to 4 (see page 2).
5, Take the complete unit, with corrugated spacor | as a provisional base, out of the box.
6.
Remove
spacers
F
and
G
and
take
the
outer
turntable
platter
out
of
the
box
(see
Fig.
3).
7. Corrugated spacers H and K should be left in position, between the inner turntable platter
and the unit plate, until the TD-150 is completely installed for maximum protection of
turntable mai
To remove the spacers, lift the inner turntable platter until they may be shifted from the unit plate.
@ Important notice
Save the complete packing for possible re-shipment. The TD-150 is a delicate instrument and would
bbe seriously damaged if forwarded in an improvised packing. (Please see our warranty conditions on
the last page of this booklet.)