Rev K Jan 2020
Page 16
Chapter 5 Standalone Operation
Chapter 5 Standalone Operation
5.1 Introduction
The LTS series of integrated long travel stages offer a fully featured motion control
capability including velocity profile settings, limit switch handling and homing
sequences. When the unit is connected to the PC, these parameters are
automatically set to allow “out of the box” operation with no further “tuning” required.
However, further adjustment is possible via the APT Server software - see Chapter .
The following brief overview explains how the top panel controls can be used to
perform a typical series of motor moves.
In conjunction with this chapter, it also may be useful to read the background on
stepper motor operation contained in Appendix D.
To Next Page
Loading...
Need help?
General
