Rev K Jan 2020
Page 8
Chapter 3 Mechanical Installation
Chapter 3 Mechanical Installation
3.1 Unpacking
3.2 Environmental Conditions
Location Indoor use only
Maximum altitude 2000 m
Temperature range 5
o
C to 40
o
C
Maximum Humidity Less than 80% RH (non-condensing) at 31°C
To ensure reliable operation the unit should not be exposed to corrosive agents or
excessive moisture, heat or dust.
If the unit has been stored at a low temperature or in an environment of high humidity,
it must be allowed to reach ambient conditions before being powered up.
The unit must not be used in an explosive environment.
Warning
The safety of any system incorporating this equipment is the responsibility of
the person performing the installation.
Caution
Once removed from its packaging, the LTS stage is easily damaged by
mishandling. The unit should only be handled by its base, not by the motor or
any attachments to the moving platform.
Note
Retain the packing in which the unit was shipped, for use in future transportation.
Warning
Operation outside the following limits may adversely affect operator safety.
To Next Page
Loading...
Need help?
General
