THORLABS PM100A - Technical Data

7.3 Technical data
56
7.3 Technical data
General Data
Detector Compatibility
Photodiode Sensors S100C Series
Thermal Sensors S300C Series
Photodiodes (max. 5mA)
Thermopiles (max. 1V)
Display Type
Graphical LCD 132 x 32 pixels +
Mechanical Analog Needle
Viewing Area
48.2 x 13.2 mm + 90,0 x 42,0 mm
Display Update Rate (max)
20 Hz
Display Format
Numerical, Mechanical Analog Needle
Backlight Display and Keypad
LED
Dimensions (H x W x D) Overall
183 x 109 x 40 mm³
Options
Kickstand; 1/4-20 Post thread
Weight
<0.5 kg
Operating Temperature
0°C - +40°C
Storage Temperature
-40°C - +70°C
Current Input (Photodiode Sensors)
Connector
DB9F, left side
Units
W
Measurement Ranges
6 decades; 50 nA - 5 mA
Ranges selectable in W, sensor depending
Display Resolution
1 pA / responsivity value (A/W)
AD Converter
16 bit
Accuracy
+/-0.2% f.s. (5µA - 5mA); +/-0.5% f.s. (50nA)
+/-3% f.s. Analog Meter
Bandwidth
DC - 100kHz, depending on sensor and settings
Wavelength Correction
nm (A/W)
Voltage Input (Thermopile Sensors)
Connector
DB9F, left side
Units
W
Measurement Ranges
4 decades; 1 mV - 1V
Ranges selectable in W, sensor dependent
Display Resolution
1 µV / responsivity value (V/W)
AD Converter
16 bit
Accuracy
+/-0.5% f.s. (10mV - 1V); +/-1% f.s. (1mV)
+/-3% f.s. Analog Meter
Bandwidth
DC - 10Hz, depending on sensor and settings
Time Constant Correction Range
1s – 30s
Wavelength Correction
Sensor depending; nm, (V/W)
Beam Diameter Setting
N/A
Analog Outputs
Connector
SMA, left side
Signal
amplified input signal – not corrected
Voltage Range
0 ... 2V
Accuracy
+/-3%
Bandwidth
up to 100kHz, depending on sensor and settings
Sensor Temperature Control
Supported temperature sensor
Thermistor
Temperature measurement range
-10°C ... +80°C ( displayed via interface only)