6.2 Firmware Update
31
6.2 Firmware Update
Firmware upgrades can be done by the user via the USB interface. Therefore install
the DFU (device firmware upgrade) wizard from the distribution data carrier.
Switch on the PM100A and enable the firmware download in the system menu:
MENU \ FW Update \ ON
(This setting will be reset to āOFFā after the unit was shut off.)
Connect the PM100A to an USB port of your PC, the PC will find a DFU device;
when proceeding the DFU wizard the first time a new DFU device will be recognized,
please allow installing.
After then launch the DFU wizard from the start bar. Follow the wizard instructions.
Please refer to www.thorlabs.com for the latest PM100A firmware version that can
be downloaded as a *.dfu file.
Do not switch off the PM100A or disconnect the USB cable while the
firmware is downloading!
To Next Page
Loading...
