THORLABS PM100A - Certifications and Compliances

7.2 Certifications and compliances
55
7.2 Certifications and compliances
Certifications and compliances
Category
Standards or description
EC Declaration
of Conformity –
EMC
Meets intent of Directive 2004/108/EEC for Electromagnetic Compatibility.
Compliance was demonstrated to the following specifications as listed in the Official
Journal of the European Communities:
EN 61326:2006
Electrical equipment for measurement, control and laboratory
use – EMC requirements:
Immunity: complies with immunity test requirements for
equipment intended for use in industrial locations
1
.
Emission: complies with EN 55011 Class B Limits
1,3
,
IEC 610003-2 and IEC 61000-3-3.
IEC 61000-4-2
Electrostatic Discharge Immunity (Performance criterion A)
IEC 61000-4-3
Radiated RF Electromagnetic Field Immunity (Performance
Criterion A)
5
IEC 61000-4-4
Electrical Fast Transient / Burst Immunity (Perf. Criterion A)
IEC 61000-4-5
Power Line Surge Immunity (Performance Criterion B)
IEC 61000-4-6
Conducted RF Immunity (Performance Criterion A)
IEC 61000-4-11
Voltage Dips, Short Interruptions and Voltage Variations
Immunity (Performance Criterion A / C
6
)
IEC 61000-3-2
AC Power Line Harmonic Emissions
IEC 61000-3-3
Voltage Fluctuations and Flicker
FCC EMC
Compliance
Emissions comply with the Class B Limits of FCC Code of Federal Regulations 47,
Part 15, Subpart B
1,3
.
EC Declaration
of Conformity -
Low Voltage
Compliance was demonstrated to the following specification as listed in the Official
Journal of the European Communities:
Low Voltage Directive 2006/95/EEC
EN 61010-1:2001
Safety requirements for electrical
equipment for measurement, control and
laboratory use.
Additional
Compliance
IEC 61010-1:2001
Safety requirements for electrical
equipment for measurement, control, and
laboratory use.
Equipment Type
Test and measuring
Safety Class
Class I equipment (as defined in IEC 60950-1:2001)
1
Compliance demonstrated using high-quality shielded interface cables shorter than 3 meters.
3
Emissions, which exceed the levels required by these standards, may occur when this equipment is
connected to a test object.
5
MOD IN port capped at IEC 61000-4-3 test.
6
Performance Criterion C was reached at additional test levels according to EN 61326-1:2006 table 2