6.4 Using the Instrument Drivers
36
6.4 Using the Instrument Drivers
The PM100USB software package contains a set of instrument drivers that allow
conveniently remote controlling the instrument in most common programming
languages. The instrument drivers must be installed, please follow the setup dialog
instructions.
To successfully complete the install of the PM100 USB drivers you
must have Administrator privileges on the PC which you are perform-
ing the install.
Prior to connecting the PM100A with the PC, please insert the data carrier that
shipped with the instrument and install the PM100 drivers. When the following
message appears after the installation you have also to install NI-VISA from the
distribution CD or from the National Instruments web site
After successfully installing the software connect the PM100A to a USB port of your
PC. The PC will find a PM100A test and measurement device. Please follow the
instructions of the dialog screens and allow the installing.
To Next Page
Loading...
