6.1 PM100 Utility Software
30
- configure unit of measure, depending on the connected sensor in W, J, dBm, V
and A
- configure the left sub display
- configure the right sub display
Shortcut: [Shift + F4]
Logging configuration button
Open dialog box to:
- set averaging rate for logging
- set interval between samples
- set number of samples
- configure logging into data file
Shortcut: Shift + F5
Start/Stop log button
- start and stop data logging
Shortcut: [Shift + F6]
Reset / Clear button
- reset min/max monitor
- clear power / energy graph
- clear power / energy histogram
- clear power / energy statistics
- clear log screen
Shortcut: [Shift + F7]
Quit button
- stops the PM100 application
- to restart press the white arrow in the tool bar
Shortcut: [Shift + F8]
To Next Page
Loading...
