THORLABS PM100D Quick Reference

Unpacking 5
© 2017 Thorlabs
2 Unpacking
Inspect the shipping container for damage.
If the shipping container seems to be damaged, keep it until you have in-
spected the contents and you have inspected the PM100D mechanically and
electrically.
Verify that you have received the following items within the hard-case:
1. PM100D power/energy meter console
2. 1GB SD memory card – installed in PM100D
3. Plug-In power supply with Interchangeable primary plug for USA, UK,
Europe, and Australia
4. USB cable, type ‘A’ to ‘mini-B’
5. Quick-start guide
6. USB memory stick with instrument drivers, user application and opera-
tion manual
7. Certificate of Calibration
3 Operating the PM100D
3.1 Preparation
Configure the plug-in power supply with the primary plug for your local power
supply.
Connect a suitable power or energy sensor. The sensors have a self-fixing
mechanism. To plug or unplug a sensor slightly press from both sides on the
pins in the connector housing.
Turn the unit on by pressing the power button in the side panel.
After switching on the unit, the graphics display will show the device status
and then jump to the last measurement screen before power down.
The PM100D is immediately ready to use after turning on.

THORLABS PM100D Specifications

General

Data Logging	Yes
Storage Temperature Range	-20 °C to 70 °C
Power Accuracy	±0.5% of reading
Interface	USB
Power Supply	USB or AC Adapter
Display Update Rate	10 Hz
Detector Type	Photodiode or Thermopile (Sensor Dependent)