GLASSWARE SANITIZING APPLIANCE
User and maintenance manual
RE V. 4
11
ENGLISH
- Battery Charger
The battery charger charges the battery tted inside the appliance thus eliminating the need
for a power supply and allowing the device to be used for mobile banquets or other outdoor
events. Please note the following: the time required to charge the appliance is between 8 and
16 hours ; the charger must only be connected to the appliance when the battery is very low.
Do not attempt to charge the appliance using chargers other than that supplied as this may
damage the appliance, causing it to malfunction, and is not covered by the warranty.
- Battery
The battery used in the machine is a LEAD-GEL 12 V 5 Ah Lithium-free battery.
It is not accessible to the user and in the event that a replacement is required, said replacement
must be performed by authorized personnel only and using spare parts with the same
characteristics.
If the machine is not in use, the battery must be recharged every 6 monts; failure to this
recommendation could cause battery damage that is not covered by warranty.
4.3. TECHNICAL SPECIFICATIONS
The technical features of the appliance are listed below:
Model VORTEX F1 PRO
Power adapter for charger 100 – 240 Vac, 50/60 Hz
Battery charger plug Italiana CEE 7/16 secondo CEI 23-5
Maximum power consumption when charging 56 W
Jet spray pressure 1 bar
Spray duration Proportional to time pressure applied
Level of IP2X protection exclusively when operated internally
Physical characteristics
Functional temperature range +10 to +40 ° C
Maximum operating altitude 2000 metres
Noise level when spraying 89 dBA
Vibrations generated during spraying are not sucient to pose any danger
Dimensions and weight of packaged product 30 x 30 x 28 cm; weight 7 Kg
Maximum number of stackable packages 3
Appliance dimensions and weight 20 x 20 x 25 cm
Power adapter dimensions and weight 11.5 x 5 x 3 cm; 220 gr,
Power cable length 140 cm
Gas cylinder dimensions and weight 4 litres Ø 14 x 59 cm; weight 11.3 Kg
Gas cylinder dimensions and weight 10 litre Ø 19 x 76 cm; weight 26 Kg
CO2 cylinder connection ISO 5145 UNI 4406 Gr2 W 21.7 x 1/14 “Ø 27 x 2
To Next Page
Loading...