GLASSWARE SANITIZING APPLIANCE
User and maintenance manual
RE V. 4
15
ENGLISH
Be careful when tightening the connection to the cylinder. NEVER turn the black box on the
solenoid valve to tighten the cylinder but instead ALWAYS use spanner No. 27, as previously
illustrated. Valve failure due to rotation during installation is not covered by the warranty.
In any case, avoid opening the black box containing the solenoid valve connected to the cylinder,
as this will result in the expiration of the warranty of the machine.
In case of need, ALWAYS contact the manufacturer.
6. OPERATION AND USE
6.1. COMPATABLE GLASSWARE
The appliance is specically designed for the sanitization of drinking glasses, decanters, jugs
and other containers, generally. The table on page 2 provides approximate time estimates for
sanitizing and chilling/freezing glasses. All sanitizing, cooling and freezing times are inuenced
by climatic and atmospheric conditions (ambient temperature, humidity, and atmospheric
pressure) and changes in these conditions may cause variances in the time required and in the
quantity of C02 consumed to achieve the same results.
6.2. OPERATING INSTRUCTIONS
1) Open the manual valve on the cylinder;
2) Using the switch, turn the appliance to the ON position;
3) Take a glass and place upside down on the rosette wheel;
4) Press down on the rosette wheel; shortly, the gas will ow out from the nozzle at a temperature
of 78.5 degrees below zero; an initial delay in supply (2 - 3 seconds maximum) is not indicative
of the appliance malfunctioning and is due to the length of the pneumatic tube connecting
the cylinder to the appliance;
5) slight variances in the force and quantity of gas supplied are determined by several factors
such as atmospheric pressure, the level of the liquid in the cylinder, temperature and
atmospheric humidity, and again are not an indication of the appliance malfunctioning;
6) After a few moments (see table above) lift the glass to cut o the gas supply; at this point the
glass is chilled, sanitized and ready to use;
7) If you wish to freeze the glass, simply repeat steps 4) and 5) above.
Applying pressure to the glass
on the rosette wheel (step 3)
Glass sanitization (step 4)
To Next Page
Loading...