11 ST PLUS ENGLISH
ENGLISH ST PLUS 11
Colored Keyboard Backlight LED
(For Illuminated Colored Keyboards Only)
Press Fn plus the key to toggle the
keyboard LED on/ off. The keyboard LED may
be configured using the Fn + key combination
outlined in the table below. In addition press
Fn plus the key to launch the keyboard
backlight application to configure the settings.
Keyboard Backlight Application
The Keyboard Backlight application can be
accessed by pressing the Fn plus key.
Modes
The buttons surrounding the swatch allow you
to alter the effects of the keyboard backlight.
Click on any of the but- tons to view the effects
on the keyboard. Click Save when exiting the
application to retain the setting.
Table 4 - Keyboard LEDs
Figure 6 Keyboard Backlight Application
Figure 5 Mode Buttons
Brightness
Click on any of the numbers (0 - 3) on the
brightness bar to set the brightness level of the
keyboard backlight.
Color Swatch
The color swatch in the top right of the screen
allows you to select a range of colors for your
keyboard backlight by clicking on the color
required. You can choose to display the swatch
either in Full Color or as an 256 Color Scheme.
Click the Custom mode button to select any
colors from the swatch and to apply your chosen
colors to parts of the keyboard.
Preview
The bottom left section of the application allows
you to preview setting changes made to colors
on the keyboard.
Keyboard Sections
The bottom right section of the application
allows you to select partial areas, or all, of the
keyboard on which to ap- ply the color changes
and effects.
Sets
The application allows you to save up to 3 sets
of color and effect combinations. Click Save
when exiting the ap- plication to retain the
settings.
Save & Exit
Click Exit to quit the application without saving,
or Save to exit and retain the settings.
Figure 7 - Color Swatch
Figure 8 - Preview
Figure 9 - Keyboard Sections
To Next Page
Loading...