T
T
r
r
o
o
u
u
b
b
l
l
e
e
S
S
h
h
o
o
o
o
t
t
i
i
n
n
g
g
…
…
Problem
Please Check
No Sound
Transmitter is not initialized
–
Re
-
check the power is
“on” at the transmitter and try changing “channels at
the transmitter.
Check the audio signal source both to and from the
transmitter. Try another cable to ensure integrity.
Check the receiver amplifier
, if used,
is powered “on”
at the mains, is not on “mute”, has no headphones
attached and that the Channels used for the
tra
nsmitter/
exterior speakers (usually A or B) is in
operation.
Refer to the owners guide that came with your
receiver amplifier.
Check the “on” switch at the Remote Control to make
sure the speaker is switched “on”
.
Check
volume c
ontrol
on your Remote Cont
rol
is
switched high enough for volume to be heard.
Check the “Green” indicator light on your speakers to
ensure they are receiving a signal.
Ensure you speakers are receiving power.
Red LED
if
batteries low
.
Ensure your speakers are receiving a signal. Gr
een
LED.
No Sound from one
speaker
Check the “balance” con
trol on your
in house
receiver
amplifier is “equal”.
Check all
connections and cable
to and from,
or
the
integrity of the transmitter source
to the inoperable
speaker.
Check the batteries or powe
r source
(s)
to the
inoperable speaker.
Left or Right
speaker sound
has
intermittent or rough
sound; the distance
of the remote
control volume
controller becomes
nearer
Loudspeaker is flashing red light
–
the battery of the
loudspeaker or remote control
will soon be out of
power. Please replace
batteries.
Check the “range” by temporarily bringing the exterior
speakers closer to the transmitter source.
Lift the transmitter height to see if this has any effect.
One speaker
sound
s
distorted,
lower volume or
“different”
Follow same procedure as above for “No Sound”.
To Next Page
Loading...
