Once the transmitter
is connected and input selected and running, hold the
Remote Control unit somewhere near your wireless speaker to begin w
ith and
press the “
ON
” button of your remote control. The red LED light should flash.
Then please bring up the volume “
VOL+
”
to an acceptable level.
Normally, the Red LED of the Remote Control will flash on in use. If you
activate the remote control and the red LED light does not light or dimmed
,
then
it is time to replace your remote control batteries.
There are two LED lights to show the operation of the receiving rock speaker
units. While working/ receiving a
sound
signal
normally
, the Green LED
light is
“on”. The Red LED
light
is not.
If the Red LED light
is
“on”
or flashing
then it is
time to replace the wireless speaker
unit’s
batteries.
To Next Page
Loading...
