The base of the TIC WRS010 wireless rock speakers contains the battery and/
or mains cable functions. Tw
o led lights show 1. Whether the unit is powered
(Green) or 2. Whether the units batteries are drained (Red).
*Always use the silicone enclosed “on/off” switch before moving or using the
unit to replace the batteries etc. Using the remote control pad on/
off switch is
not
the same. You must use the
silicone enclosed
rocker switch to ensure the
unit is off or it still consumes power.
The WRS010 broadcast
unit provides an uninterrupted signal to the wireless
rock speakers for 300’
(100m)
if unobstructe
d. The level of obstruction, if any,
will mitigate the sound performance of this unit. The unit provides for eight
separate channels for clearer listening once you press the “CH”
button
on the
transmitter.
Try to keep the transm
itter unit
higher than
the r
eceiving units for
clarity of signal transmission.
Please carefully remove the red dust cap and attach the antenna, vertically
upward, to the back of the transmitter unit during set
-
up. Tighten carefully by
hand only. Connect the mains power transformer a
nd any audio inputs you
desire. Switch the transmitter “on”, the red light will glow.
To Next Page
Loading...
