TIC WRS010 - Exterior Installation

The WRS010 wireless rock speakers full featured remote . Look for the Red led
light to flash when any control is activated
We equip each remote control transmitter w ith a MN21/23 or A23 battery or
equivalent . These batteries require replacing when the remote controls distance
becomes shorter or failures occur in the remote control s operation.
E
E
x
x
t
t
e
e
r
r
i
i
o
o
r
r
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
…
…
1. Carefully unpack your new TIC WRS010 outdoor wire less rock
speakers and inspect all components as previously described.
2. Don’t forget to test your new unit prior to exterior installation.
3. Carefully connect the mains 110/220v power cord to the broadcast
transmitter placed near your receiver amplifier sourc e.
4. Connect your broadcast unit to your chosen receiver amplifier with
either the 3 .5mm jacks direct or the with the color coded phono, (RCA)
type plugs supplied.
5. Carefully connect the mains 110/220v power cord to your WRS010
rock speakers. (First, prior to battery trial)
6. Attach any input devices , CD, MP3’s etc. as desired.
7. Power up your in house receiver/ amplifier and the n the broadcast unit
checking for “on” led signal lights.
8. Switch your wireless rock speakers “on” using the silicone covered
rocker switc h at the base of the unit checking for the Green signal
source led light on.
9. Switch your wireless rock speakers “on” using the Remote Control on /
off switch .
10. Test the unit using as many “modes” of operation as possible. Try
changing the broadcast frequenc y channels at the transmitter to check
for clearer reception alternatives. (CH on the transmitter).
11. When all is satisfactory try the batteries only , disconnecting the mains
power cord accordingly.