MAINTAINING YOUR TIDALFIT
REMOVING, INSTALLING AND CLEANING FILTERS
These are the steps needed to successfully replace your lters You should
replace your disposable pool lters and clean your non-disposable lters
every four months.
1) Turn off all power to your pool and remove the lter lid by lifting it out
towards you.
2) Turn the lter counterclockwise and remove it from the lter well.
3) Dispose of the used lter.
4) To replace, set screen back into its place turn clockwise to fasten. DO
NOT over-tighten.
5) Place the new lter into position and turn clockwise to fasten. DO NOT
over-tighten.
6) Follow the directions 1) and 2) for the pleated lter cartridge. You then
rinse the lter with a garden hose and soak the lter in a mixture of one
pint of lter cleaner with 2.5 gallons of water for at least 12 hours. The
lter must be completely submerged. You then follow the directions 4) and
5) to replace the lter
WARNING: Power to your pool must be turned off prior to remov-
ing your lters. The suction at the lter is extremely strong and can
cause injury if there is no lter. NEVER run your pool without the
lters properly installed. Injury to person and damage to the equip-
ment can occur. Any damage to equipment due to this circumstance
will not be covered under warranty.
WINTERIZING YOUR TIDALFIT
It is not recommended that you drain your pool completely during freezing
conditions. We recommend that you leave your pool full of water with the
power on to keep the tub from freezing. If you decide to drain your pool
during freezing conditions, contact your dealer for help. Contact your
dealer before relling a drained pool in freezing temperature.
WARNING: Damage to your pool caused by freezing is NOT covered
under warranty. Please contact your local Artesian dealer to assist you in
winterizing your pool.
58
To Next Page
Loading...
