Index
1. Safety and Printing Environment.........................................................................................5
1.1 Safety Precautions........................................................................................................................5
1.2 Printing Environment..................................................................................................................6
1.3 One Year Warranty..................................................................................................................... 6
1.4 Compliance................................................................................................................................... 6
2. Unboxing............................................................................................................................... 7
2.1 Unboxing the UP300D................................................................................................................. 7
2.2 What’s in the box......................................................................................................................... 8
3. Introduction...........................................................................................................................9
3.1 Main Parts of UP300D.................................................................................................................9
4. Printer Installation.............................................................................................................. 10
4.1 Install the Print Board...............................................................................................................10
4.2. Install the Software UP Studio 3.0...........................................................................................11
4.3 Update the Touchscreen Firmware.......................................................................................... 11
5. Prepare UP300D for Printing.............................................................................................12
5.1 Connectivity................................................................................................................................12
5.2 Auto Calibration........................................................................................................................ 12
5.3 Auto Calibration from Touchscreen........................................................................................ 12
5.3 Load the Filaments.....................................................................................................................13
6. First Print............................................................................................................................ 16
6.1. Slicing......................................................................................................................................... 16
6.1.1 Open UP Studio 3....................................................................................................................16
6.1.3. Load an STL file.....................................................................................................................17
6.1.4. Auxiliary Support (A.S.)........................................................................................................18
6.2 Connect and Send Print Job to Printer....................................................................................20
6.3 Remove Printed Models.............................................................................................................21
7. Printer Calibrations.............................................................................................................22
7.1 Nozzle Height Measurement..................................................................................................... 23
7.2 Setup Nozzle Height Value through Wand..............................................................................23
7.3 Matrix Leveling (9-Point Compensation)................................................................................ 25
7.3.1 Auto Matrix Leveling through Wand................................................................................... 26
7.4 Manual Calibration....................................................................................................................27
8. Introduction to UP Studio 3 Package.................................................................................29
9. Introduction to the UP Studio, the Slicer........................................................................... 31
9.1 Interface...................................................................................................................................... 31
9.2 Quick Setting Bar.......................................................................................................................31
9.3 Print Layout Tools..................................................................................................................... 31
9.4 Support Editor............................................................................................................................33
To Next Page
Loading...
