EasyManuals Logo

Tiger JPB-G18S User Manual

Tiger JPB-G18S
65 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
15
14
15
14
English
1
Measure the rice.
Always use the measuring cup supplied with
the rice cooker (for rinse-free rice as well).
A level lling of rice in the supplied measuring
cup equals about 0.18 L.
Fill the measuring cup as shown below.
Correct
measurement
Incorrect
measurement
Note
Always use the specied volume of rice (see
“Specications” on P.45). Otherwise the rice
may not cook properly.
If other ingredients are to be added to the rice,
see P.12.
Do not mix in amaranth or other small grains that
may cause clogging. Doing so may cause the
clogged pressure adjusting hole or safety valve,
which may lead to steam leak or boiling over
resulting in burn or injury.
2
Wash the rice. (This can be
done using the inner pot.)
For rinse-free rice, see P.12.
Note
Do not use hot water (over 35°C) to wash the
rice or when adding water. It may prevent the rice
from cooking properly.
3
Adjust the water level.
Place the inner pot on a level surface and
adjust the water level to the appropriate line
of the corresponding scale on the inside of
the pot.
The water level should be selected according
to the type of rice and the selected cooking
menu, but can be ne-adjusted to your personal
preference. (See the guidelines on P.12.)
When cooking 3
cups of white rice,
adjust the water
level to line “3” on
the “Plain” scale.
4
Wipe off any water drops and
rice grains on the inner pot, and
check for clogging of the inner
lid.
<Outer surface and brim of the inner pot>
<Inside the rice cooker>
Inner lid
Upper casing
Catch
Center
sensor
Inside the rice
cooker
3
Before Cooking Rice
<Inner lid>
Detaching/attaching the inner lid (See P.32.)
Pressure reducing hole
(Gasket for
depressurization)
Pressure adjusting
holes
Tab
Knob
Note
Be sure to remove any rice or other material adhering
to and around the heater plate, center sensor, upper
casing, and the hook button. (See P.31.)
Adhering material can prevent the lid from
closing, allow steam to leak out during cooking, or
enable the lid to open and the contents to spray
out, resulting in burns or other injury.
5
Set the inner pot in the body
and close the lid with both
hands until it clicks.
(1) Set pot inside
rice cooker.
(2) Close lid.
Inner
pot
Inner lid
Click
Do not press
any operation
keys.
Note
As the inner pot of the pressure induction heating
rice cooker has high hermetic sealing, the lid
may be difcult to close. Conrm that the lid is
completely closed.
6
Connect each end of the power
cord to the specied locations.
Blinks
Appliance plug
(1) Connect
(2) Connect
Power plug
Note
If the Keep Warm lamp is on, press the [Cancel]
key to turn off the lamp.
Blinks
On
Off
Beep
If the [Start/Rinse-free] or [KeepWarm] key is
pressed without the inner pot being set, an alarm
(3 beeps) will sound.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tiger JPB-G18S and is the answer not in the manual?

Tiger JPB-G18S Specifications

General IconGeneral
BrandTiger
ModelJPB-G18S
CategoryRice Cooker
LanguageEnglish

Related product manuals