15
www.timberk.com storage water heater
ENGLISH
11. Normal heat indicators
They light up when selecting medium heating power (1200 W).
12. Set temperature indicator
13. Button « »
It is used to increase the selected value.
14. Control panel lock indicator
15. Button « »
It is used to decrease the selected value.
1. « » button
It is used to decrease the selected value.
2. TIMER button
It is used to activate timer and night heating.
3. ON/OFF button
It is used to switch on/off the appliance.
4. « » button
It is used to increase the selected value.
5. MODE button
It is used to set time and timer.
1
2
4
5
3
Mounting of batteries
The remote controller is power supplied from two AA batteries (not
included in the set of delivery), installed in a special compartment
whose cover is located on the back panel of the remote controller. To
mount batteries:
1. Remove the cover of the battery compartment by sliding it along the
direction of the arrow.
2. Mount batteries, observing specified polarity.
3. Place the cover back.
Fig. 14
The remote controller should be directed to the signal receiver, located
on the water heater. The water heater confirms receipt of the control
command by a sound signal.
IMPORTANT!
1. Prevent contact of the remote controller with water and other
liquids. Prevent contact of the remote controller with direct
sunlight and do not leave it nearby heaters and electric
appliances.
2. Prevent contact of direct sunlight with the infrared signal
receiver on the unit
Remote control for FS5/FS6 series
To Next Page
Loading...
Need help?
General
