4. Clock setting
4.1. When the water heater is on, press mode button once, and clock
value will start blinking on the display.
4.2. Press button to increase hours, in increments of 1 hour for
single pressing.
4.3. Press button to increase minutes, in increments of 1 minute for
single pressing.
4.4. When the desired time will be set, do not press any buttons, the clock
will keep blinking for 5 seconds and then setting will be completed and the
clock will start counting.
5. Timer setting
5.1. Water heater activation timer setting
5.1.1. When the water heater is on, press mode button twice and the clock
[00:00] on the display will start blinking.
5.1.2. Using buttons and set the desired water heater activation
time (see item 4.2, 4.3).
5.1.3. . When the desired time will be set, do not press any buttons, the
clock will keep blinking for 5 seconds and then setting will be completed.
5.2. Water heater deactivation timer setting
5.2.1. When the water heater is on, press mode button three times and the
clock [00:00] on the display will start blinking.
5.2.2. Using buttons and set the desired water heater
deactivation time (see item 4.2, 4.3).
5.2.3. When the desired time will be set, do not press any buttons, the clock
will keep blinking for 5 seconds and then setting will be completed.
5.3. Timer activation
When the water heater is on, press timer button once and indicator
will light up on the display and TIMER word will light up under the clock,
after that the water heater on/off timer will be activated, and heating will
be switched off (if it was on).
5.4. Timer deactivation
Press timer button 3 times, indicator and TIMER under the clock
will light down, after that the water heater on/off timer will be deactivated.
6. Night heating
When this function is activated, water heating will be performed only at
night, from 23:00 to 06:00. Heating will be impossible during other hours.
6.1. Press mode button twice to activate night heating, at that
indicator on the display will light up.
6.2. Press mode button twice again to deactivate night heating, at that
indicator on the display will light down.
7. Timer and night heating
Timer and night heating can be activated simultaneously. For this purpose
it is necessary to press timer button several times until timer and night
heating indicators light up simultaneously.
8. Control panel locking
8.1. Press and hold mode button on the control panel of the water heater
for 3 seconds to lock control buttons, at that indicator on the display
will be shown.
8.2. Press and hold mode button on the control panel of the water heater
for 3 seconds again to unlock control buttons, at that indicator on the
display will light down.
9. Switching off
Press the temperature controller handle and hold it for several seconds or
press ON/OFF button on the remote controller to switch off the
appliance, at that indicator lights will light down and the temperature
controller handle back lighting will stay on.
8. MAINTENANCE
Fig. 15
Fig. 17
Fig. 16
Drain knob
Screw
Depressurization hole
19
www.timberk.com storage water heater
ENGLISH
To Next Page
Loading...
Need help?
General
