CHRONOGRAPH OPERATION:
The chronograph can measure up to 1 hours in one
second increments. Pusher A starts and stops the
chrono operation. Pusher B is for reset.
To measure elapsed or split time:
1. PRESS pusher A to start timing
2. PRESS pusher B to stop timing. The stopwatch
continues to count seconds
elapsed but the hands do not move.
3. PRESS pusher B again to resume timing.
The hands move quickly to indicate elapsed time
and continue counting.
NOTE: The hour, minute and second hands on the
watch will continue to indicate
the correct time while using the stopwatch.
1 2
A
B
CHRONO
MINUTE
CHRONO
SECOND
24 HOUR
HAND
To Next Page
Loading...
