Before setting the time, check if the dual time of 24 hour hand is in the “0”(24 o’clock) position. If the dual
time of 24 hour hand is not in the “0” position, reset them following the procedure below. The battery setting
and after battery change, please execute the “0” position adjustment.
1. Pull out the crown
VD31...second click
VD32...first click
2. Keep the buttons “A” & “B” pressed at the
same time more than 2 seconds, and then
release the buttons.
* Dual time of 24 hour hand moves. Returned
to where it was. However, confirmation is
difficult because the amount of movement is
small.
ADJUSTING THE DUAL TIME OF 24 HOUR HAND POSITION
To Next Page
Loading...
