2. STOPWATCH HAND POSITION ADJUSTMENT
1. When the stopwatch is or has been measuring or is stopped, if the crown is pulled out to the second
click, it will automatically reset the STOPWATCH hands to “0”.
2. It is recommended that the hands be set to the time a few minutes ahead of the current time, taking
into consideration the time required to adjust the STOPWATCH hand position if necessary.
3. When setting the hour hand, be sure to check that AM/PM is correctly set. The watch is so designed
that the date changes once in 24 hours.
4. when setting the minute hand, first advance it 4 to 5 minutes ahead of the desired time and then turn
it back to the exact minute.
24-HOUR SUB-DIAL SETTING:
The 24-hour hand moves correspondingly with the hour
and minute hands. When setting the time be sure to
check that the 24-hour hand is set properly.
If the STOPWATCH hands are not in the
“0” position, follow the procedure below to
set them to the “0” position.
To Next Page
Loading...
