•
Use the Setup Card and adhesive foam disks to keep track of
location buttons, until you can mount them in their final loca-
tions. Mount the buttons with the foam disks, the button
mounts, or both.
•
You will probably want to keep incident buttons in the button
wallet provided with the G
UARD
1 P
LUS
system. You can order
additional wallets and make duplicate sets as needed.
16
••
Set Up Your Buttons Installation Guide
Method 2 - Reading buttons with T
HE
PIPE
Before using this method, you must
clear T
HE
PIPE.
1. Place T
HE
PIPE in the Direct
Downloader.
2. Select the System tab.
3. Right click on the PIPE you
want to clear.
4. Select Clear.
This method can be used when
buttons are already mounted in the
field, or with buttons you intend to
mount later.
To Next Page
Loading...