Timewave DSP-599zx - Modem Assignment; FSK Mark Control

DSP-599zx Audio Noise Reduction Filter
March 6, 1997 6-11
Modem Assignment
You can select which output channel will be used for the internal RTTY Mo-
dem. This does not affect any other operating mode. You can select to send
RTTY Modem signals to A, B, or A&B. You may also select to turn it off.
The factory default is A&B.
1. Press
[Shift+Mode]
twice to enter Setup mode.
2. Rotate left knob until
'DWD
appears on the bottom line of the display
3. Press the left knob to select.
4. Rotate left knob until
0RGHP $VVLJQ
appears on the bottom left of
the display.
5. Press the left knob to select.
6. Rotate left knob until the chosen value appears on the bottom right of
the display Your choices are
$
,
%
, or
$%
.
7. Press the left knob to accept choice and save. Press middle knob to
escape without saving changes.
8. Rotate left knob until your next function to change appears on the bot-
tom line of the display or press the middle knob to return to main set-
up menu.
FSK Mark Control
With some transceivers, the normal configuration for Mark within the FSK
signal be reversed and not adjustable. Standard convention is for Mark to be
at the lower frequency. Channel A and B are separately configurable. Your
choices are Normal (
1RU
) or Reverse (
5HY
). The factory default is Normal.
Function
6
Shift
5
AGC
3
Bypass
Setup
TestData
DSP-599zx
CW
Voice
Mode
Rcl/Store
Spkr/Chan
1
Random
4
Tone
2
599-088
High Pass
Center Freq
Time
Function
6
Shift
5
AGC
3
Bypass
Setup
TestData
DSP-599zx
CW
Voice
Mode
Rcl/Store
Spkr/Chan
1
Random
4
Tone
2
599-089
High Pass
Center Freq
Time