Timewave DSP-599zx - Default CTCSS Tone; CTCSS Trigger Threshold

DSP-599zx Audio Noise Reduction Filter
March 6, 1997 7-9
Default CTCSS Tone (Version 4 firmware only)
You can adjust the default CTCSS tone that will appear when you turn the
CTCSS test function on.
1. Press
[Shift+Mode]
twice to enter Setup mode.
2. Rotate left knob until
7HVW
appears on the bottom line of the display
3. Press the left knob to select.
4. Rotate left knob until
&7&66 'IOW
appears on the bottom left of the
display
5. Press the left knob to select.
6. Rotate left knob until the chosen value appears on the bottom right of
the display
7. Press the left knob to accept choice and save. Press middle knob to
escape without saving changes.
8. Rotate left knob until your next function to change appears on the bot-
tom line of the display or press the middle knob to return to main set-
up menu.
CTCSS Trigger Threshold (Version 4 firmware only)
You can adjust the level that the CTCSS tone will trigger the squelch to
open. The factory default is 20 mV.
1. Press
[Shift+Mode]
twice to enter Setup mode.
2. Rotate left knob until
7HVW
appears on the bottom line of the display
3. Press the left knob to select.
Function
6
Shift
5
AGC
3
Bypass
Setup
TestData
DSP-599zx
CW
Voice
Mode
Rcl/Store
Spkr/Chan
1
Random
4
Tone
2
599-082
High Pass
Center Freq
Time
Function
6
Shift
5
AGC
3
Bypass
Setup
TestData
DSP-599zx
CW
Voice
Mode
Rcl/Store
Spkr/Chan
1
Random
4
Tone
2
599-083
High Pass
Center Freq
Time