76
77
date to your local date, continue rotating the crown to
position the hands to the current local time, being mindful
of am/pm. Once the time is set, push the crown back in
to the closed position. In normal operation the 4th center
hand will display the date when the crown is pushed.
The hand will travel to the position of the current date as
shown on the top ring of the case. The hand will pause
for you to be able to read the date and then return back
to the 12 o’clock resting position. Please note that the
Perfect Date
™
function will only operate in the Time
mode. When the battery is depleted and is replaced, the
Perfect Date function must be recalibrated. When the
battery requires replacement, it is highly recommended
the watch be sent to a Timex service center, where the
battery will be replaced and the Perfect Date function will
be recalibrated to the current date for the location where
the watch is to be returned.
4TH CENTER HAND ADJUSTMENT
To readjust a misaligned 4th center hand:
1. Pull the crown out to position 3. The upper and lower
hands reset to the ends of their sweeps automatically.
2. Within 10 seconds of pulling the crown to position 3,
the 4th center hand should point to 12 o’clock, if it
does not point to 12 o’clock, press button A or B to
move the hand counterclockwise or clockwise until
it points to 12 o’clock. Pressing and holding button A
or B will make the hand move at a fast rate. Please
note: after 5 seconds without action with the crown
in position 3, the 4th center hand will move to display
the current date.
3. Push crown in to position 1 when finished.
To Next Page
Loading...
Need help?
General
