To Sync the Watch with a Computer
1. Make sure the Data Xchanger USB device is plugged into a USB port
on your computer and the Timex
®
Trainer device agent desktop
software is running.
2. Press MODE until Sync Mode appears.
3. You will see the message SYNC READY indicating the watch is ready to
initiate communication with a computer.
4. Press HEART RATE to begin the sync process.
5. The watch will suspend and reset all other watch activity and begin
searching for a computer. You will see the message SEARCHING FOR
PC.
6. Plug the USB device into a computer and open the device agent
software.
7. When the link is established with a computer, the watch will display
the device message SYNCING WATCH until the sync process is finished
at which time the watch will display the message SYNCING DONE. The
watch will sound an alert and return to the SYNC READY state.
5352
Sync
This mode allows you to transfer your workout data to Timex
®
Trainer
software when used with the optional Timex
®
Data Xchanger USB device.
START/SPLIT
Press to cancel the search for or sync with a computer once the sync
process has begun.
INDIGLO
®
BUTTON
Press to light the watch, activate/de-activate the Night-Mode
®
feature.
MODE
Press to move to the next mode.
STOP/RESET/SET
Press to cancel the search for or sync with a computer once the sync
process has begun.
HEART RATE
Press to enable the receiver and startsearching for a computer
NOTE: Once you have initiated the sync process, you can press any button
to cancel. You will see the message SYNC CANCEL. The watch will beep,
the receiver will shut down, and the watch will return to the SYNC READY
state.
To Next Page
Loading...
Need help?
General
