Timotion TA16 - Glossary

User Manual-TA16
Version D January 2021
3 of 22
3
Glossary
The following terms and acronyms are being used in this manual.
 Vm+: The positive pole of power input.
 Vm-: The negative pole of power input.
 RPM: Number of turns per minute.
 AWG: American wiring gauge.
 LS: Limit switch installed inside the outer tube.
 Up LS: Upper limit switch is installed in fully extended end of stroke.
 Low LS: Lower limit switch is installed in fully retracted end of stroke.
 Mid LS: Middle limit switch is installed and the position is set by customer’s request.
 N.C.: It is the pin of limit switch which is normally short circuit and changed to open when the switch is
triggered.
 N.O.: It is the pin of limit switch which is normal open and changed to short circuit when the switch is
triggered.
 C.: It is the common pin of limit switch when the circuit is either open or short.
 Vp: The reference voltage input to POT signal.
 Vout: The POT signal wire output value.