EN
24
In more detail...
EN
Product functions
Intended use
This belt sander is designated with a rated input of 900 Watts.
as beams and boards. It is also suitable for bevelling edges and cutting rebates.
The product must be used in an upright position only with the front plate laying
on a work bench.
operation and to observe all the instructions therein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
Planing depth
WARNING! Always switch the product off and disconnect it from power
supply before making any adjustments!
Adjust the desired planing depth by turning the knob for cutting depth adjustment
(17). The depth can be adjusted between 0 and 3 mm. The number on the scale
(16) next to the pointer indicates the depth of cut in 0.1 millimetre steps (Fig. 5).
16
17
Fig. 5
Turn knob (17) / Position front plate Planing depth Blades (19)
retracted to maximum
position
increased fully lowered
for maximum
cut
TTB876PLN by TITAN
To Next Page
Loading...
Need help?
General
