EN
34
In more detail...
EN
Troubleshooting
Troubleshooting
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does
not start
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect
to the product
1.1. Connect to power supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e. g.
generator) has too low
voltage
2.3. Air vents are blocked
2.1. Use a proper extension
cord
2.2. Connect to another
power source
2.3. Clean the air vents
3. Unsatisfac-
tory result
3.1. Blade is dull/damaged 3.1. Replace with new one
4. Excessive vi-
bration /noise
or exhaust
4.1. Blade is dull/damaged
4.2. Bolts/nuts are loose
4.1. Replace with a new one
4.2. Tighten bolts/nuts
TTB876PLN by TITAN
To Next Page
Loading...
Need help?
General
