4
power socket through a multi-outlet power strip, a
total current consumption of the appliances must
not exceed the allowable current capacity of the
power socket.
Failure to observe this instruction may result in a
a multi-outlet power strip, never remove the power
strip from a power source.
in locations exposed to the direct sunlight, near the
heaters, or in locations generating sooty smoke
electric shock.
designed exclusively to be mounted in an equipment
rack. Be sure observe the following instructions
when rack-mounting the unit. Failure to do so may
Fix it with anchor bolts or take other arrangements
to prevent it from falling down.
· The supplied rack-mounting screws can be used
for the TOA equipment rack only. Do not use them
for other racks.
orientation) when connecting the power supply
cord. Reversed polarity connections will cause
damage to the system.
When the Unit is in Use
Note that the use of other power supply unit may
not result from leakage or explosion of the battery.
· Do not short, disassemble, heat nor put the battery
· Avoid using both new and old batteries together.
· Never charge batteries of the type which are not
rechargeable.
· Do not solder a battery directly.
· Note correct polarity (positive and negative
orientation) when connecting a battery to the unit.
· Avoid locations exposed to the direct sunlight,
high temperature and high humidity when storing
batteries.
2. FEATURES
Evacuation Systems (VX-2000, SX-2000, and VM-3000).
charging voltage.
To Next Page
Loading...