PRE-OPERATING PREPARATIONS22
6
1. Full open the air vent screw on the
tank cap and release internal pres-
sure.
1. Air vent screw
2. Fuel tank cap
2. Open the fuel tank cap slowly.
3. Fill the fuel not to over the shown
level.
1. Full line
4. After filling the tank, close the fuel
tank cap until two clicks sound is
heard.
ENOM00037-1
ENOW00022-1
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine.
ENOW00092-C
z Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of oil gauge, drain oil to level lower
than upper limit.
z Be sure that outboard motor is in upright
and level position when checking or
changing oil.
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
1. Place the engine in a vertical posi-
tion.
2. Remove the top cowl and the oil filler
cap.
3. Fill the engine through filler port with
recommended oil to the FULL mark.
4. Tighten the oil filler cap.
3. Engine oil filling
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
