TOHATSU MFS 3.5C User Manual

ENGINE OPERATION 29
7
4. Remove the recoil starter.
5. Tighten the three bolts (A, B, C) fas-
tening the tank and one bolt (D) fas-
tening the recoil starter.
6. Insert the knotted end of the starter
rope into the notch in the flywheel
and wind the rope around the fly-
wheel several turns clockwise.
7. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench that is included in the
tool kit.
8. Set the control lever in the Neutral
position.
9. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it
quickly.
10. After engine starts, do not reinstall
recoil starter and top cowl.
ENOM00043-B
ENOW00932-0
Be sure to check that cooling water is com-
ing out of the cooling water check port dur-
ing warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
-1
(rpm) :
below 5°C (41°F)
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOF00220-0
A
B
C
D
ENOF00221-0
ENOF01610-0
3. Warming up the engine
CAUTION
ENOF00222-1

TOHATSU MFS 3.5C Specifications

General

Brand	TOHATSU
Model	MFS 3.5C
Category	Outboard Motor
Language	English