37
8
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOM00070-H
ENOW00064-0
Engine may be hot immediately after operat-
ing and could cause burns if touched. Allow
engine to cool down before attempting to
carry the outboard.
1. Cooling water check port
1. Stop the engine.
2. Close the fuel cock and tighten the air
vent screw of the tank cap.
3. Loosen clamp screws by hand.
4. Remove the outboard motor from the
boat and completely drain the water
from the gear case in a vertical posi-
tion.
ENOM00071-A
ENOW00065-0
Close air vent screw of fuel tank before car-
rying or storing outboard motor and fuel
tank, or fuel may leak, potentially catching
fire.
ENOW00066-0
z Do not give a shock to an outboard motor
during transportation. It becames a cause
of breakage.
z Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
1. Removing the outboard
motor
CAUTION
1
ENOF00223-2
2. Carrying the outboard motor
WARNING
CAUTION
ENOF01607-1
To Next Page
Loading...
Need help?
General
