INSPECTION AND MAINTENANCE42
10
ENOM00228-0
Perform the following checks before and
after use.
ENOW00078-1
Do not use outboard motor if any abnormal-
ity is found during pre-operation check oth-
erwise it could result in severe damage to
the motor or severe personal injury.
1. Daily Inspection
WARNING
Item Points to Check Remedy
Fuel System
• Check the amount of fuel in the tank. Fill fuel
• Check for debris in the fuel filters. Clean or Replace
• Check the rubber hoses for fuel leakage. Replace
Fuel Tank Cap
• Check for crack, leakage, damage in the fuel tank cap. Replace
• Check for crack, damage in the gasket and tether. Replace
• Check for leakage at full close. Replace
• Check for ratchet performance. Replace
Engine Oil • Check the oil level, dirt and entering water. Fill fuel or Replace
Electrical
Equipment
• Check that the stop switch functions normally and make sure
the lock plate is in right location.
Remedy or replace
• Check cords for loose connections and damage. Correct or replace
• Check the spark plug for dirt, wear and carbon build-up. Clean or replace
Throttle System
• Check that the carburetor choke valve functions normally. Replace
• Check carburetor linkage is working normally when turning the
throttle grip.
Correct
Recoil Starter
• Check the rope for wear and chafing. Replace
• Check the ratchet engagement. Correct or replace
Clutch and
Propeller Sys-
tem
• Check that the clutch engages correctly when operation the
shift lever.
Adjust
• Visually check the propeller and shear pin for bent or damaged
blades.
Replace
• Check that the split pin is on the propeller.
Installation of
Motor
• Check the clamp screws attaching the motor to the boat for
tightness.
Tighten
• Check the thrust rod installation.
Cooling Water
• Check that cooling water is discharged from the cooling water
check port after the engine has started.
Tools and
Spares
• Check that there are tools and spare parts for replacing spark
plugs, the propeller, etc.
• Check that you have the spare rope.
Other parts
• Check if the anode is securely installed. Repair if necessary
• Check the anode for corrosion and deformation. Replace
To Next Page
Loading...
Need help?
General
