INSPECTION AND MAINTENANCE48
10
1. Drain hole
4. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
18Nm (13 ft
-lb, 1.8 kgf-m)
5. Remove the top cowl and the oil filler
cap.
6. Fill the engine through filler port with
recommended oil (See page 23) to
the FULL mark.
7. Tighten the oil filler cap.
1. Oil filler cap
2. Oil level gauge
3. Upper level
4. Lower level
ENON00920-0
Note
Use only recommended engine oil (See
page 23)
ENOW00925-0
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00031-0
Note
z If any amount of water is found in
engine oil, making it milky white, consult
dealer.
z If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
z Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
ENOF01616-1
1
FULL
LOW
3
4
1
2
ENOF00239-1
Oil volume needed for complete oil replacement
Approximately 300 mL (10 fl.oz.)
CAUTION
ENOF00240-1
To Next Page
Loading...
Need help?
General
