ENGINE OPERATION38
7
6. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
repeat if necessary until started.
1. Slowly
2. Quickly
(For electrical starter type)
4. Push the starter switch button and
release the button when the engine
has started.
1. Starter Button
ENOW00032-0
Do not keep turning starter motor for over
5 seconds, or the battery may be con-
sumed, potentially making the engine start-
ing impossible and/or damaging the
starter.
If cranking over 5 seconds fails to start
engine, return main switch to “ON”, and
crank engine again after 10 seconds or
more.
5. Check the cooling water from cooling
water check port.
Side mount RC type
1. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
1. Stop switch lock
2. Insert the main switch key.
3. Set the control lever in the Neutral
position.
4. Raise the free accel lever a little (both
of cold engine and warm engine).
CAUTION
To Next Page
Loading...
Need help?
General
