14
Modular Conversoin Receiver Model: R-CM
5 Handling
5. How to Use
5-1. Installation/Remove way of the Radio Module
5-1-1. How to Install the Radio Module to Receiver
* Be sure to attach the antenna to the radio module before mounting the module on receiver.
1. Open the front cover of receiver and
t the module to the board.
2. Take care not to pinch the metal ttings by the
module.
Attach the module to the board by aligning the
protrusions on the module with the guide holes on
the board.
3. After installing the module on the receiver,
push it inward until the metal ttings on both sides
enter the groove of the module.
* If the module does not enter even if it is pressed,
the module may not be installed correctly.
Make sure that the module is installed correctly
and do not push the lever in.
To Next Page
Loading...
General