Maglink LX
User Manual | Power On/Power Off
Rev. 9, 04-2016
Page 10 of 40
6
P
OWER
ON/OFF
IMPORTANT: Only authorized/trained personnel following the installation inline with the
manufactures instructions can switch on the console. This operation must be in accordance
with the instructions of the Installation Manual and according to Safety Instructions.
The following table lists the steps necessary to switch on the console:
Step Description
1 Check that the power button is OFF (0)
2 Connect the power cable.
3 Connect the corporate network cable, if required
4 Press the power button ON (1)
When switched on if the console is not configured it will emit an alarm when it does not communicate with
any tank. Press the red arrows up and down until you reach the page "ALARM LOG" and press the ACK
button to silence the alarm.
For any changes to be made to the console configuration, refer to the manual "Configuring the Console.”
The following table lists the steps necessary to switch off the console:
Step Description
1 Press the INFO button at the top right of the screen
2 Press the "Off" button within the INFO page
3 Wait for the screen to turn black
4 Press the power OFF (0) button on the console
IMPORTANT: If the console is switched OFF simply removing power the SD card might be
damaged and the console might not restart. If this happen a new SD card is needed and the
image of the Operating System and application should be loaded, and at last the backup
restore in order to have the previous saved configuration
The Console needs to be shut down from info page before removing power for proper
operation.
To Next Page
Loading...
