Your Tokio Wireless can connect with two Bluetooth devices at most. If you want
to finish the multi-pairing, please refer to the following steps:
1) Firstly, pair and connect Tokio Wireless with Bluetooth device one (refer to
“pairing Tokio Wireless with a Bluetooth cell phone”);
2) Turn off Tokio Wireless and make it enter paring mode again, pair and connect
with Bluetooth device two(refer to “pairing the Tokio Wireless with a
Bluetooth cell phone”);
3) Operate Bluetooth device one to connect with Tokio Wireless. Thus, Tokio
Wireless has already connected with Bluetooth device one and two, the Tokio
Wireless also can connect with these two devices automatically next time.
Remarks:
After successful multi-pairing, the paired devices will remember each other.
Tokio Wireless will connect with last connected two devices automatically
after turn on.
To improve the stabilization of Tokio Wireless, we suggest you turn off the
multi-pair function when you only connect with one cell phone.
3. Re-connecting with a Bluetooth device
1) Automatic connecting
Every time your Tokio Wireless is turned on, it will connect to last connected
device automatically.
2) Manual connecting
When your Tokio Wireless is in standby mode and not connect with device, short
press any button, it will try to connect to last connected device.
Remarks:
Before connecting to a Bluetooth device, please turn on the Bluetooth function
of Bluetooth device.
For some Bluetooth devices, for example, Nokia cell phones, you have to
allow automatic connecting in the cell phone’s settings. Please refer to your
cell phone’s manual for further information.
9
To Next Page
Loading...