8. Factory Reset
In the status of standby mode and not connect with Bluetooth device, long press
MFB and button for 3~4 seconds simultaneously and release it until the red
and blue LED on simultaneously.
Remarks:
For factory reset, you should press MFB button first, then press button or
press MFB and button simultaneously.
After factory reset, the paired list of Tokio Wireless will be deleted, when you
turn on Tokio Wireless again, it will enter paired mode automatically, but it
won’t connect with device automatically, you should re-pair and connect with
devices.
Important maintenances precautions
In order to offer your Tokio Wireless good maintenances, please always follow the
below basic precautions:
Keep it dry and don’t put it in the dump place to avoid the product’s internal
circuit being affected.
Keep the product away from direct sunlight or hot places. High temperatures
will shorten the life of electronic devices, destroy the battery or distort certain
plastic parts.
Don’t use this product during sport to avoid the sweat into product so that
damage the product. This product is not water-resistant.
Don’t expose the product to cold areas. It may damage the internal circuit
board.
Don’t try to disassemble the product as it may get damaged if you are not
professional.
Don’t let it fall down onto the floor or other hard surfaces. The internal circuit
might get damaged.
Don’t use intensive chemical products or detergent to clean the product.
Don’t scratch the surface with sharp things.
14
To Next Page
Loading...