Why is no temperature or air volume setting possible on my TOOLCRAFT Rework station?
If you are unable to set the temperature or air volume, the button lock may be switched on. Please, switch off the button lock.
Why is the pre-set temperature not correct on my TOOLCRAFT Rework station?
The pre-set temperature may be incorrect because the hot air cools down as it moves from the temperature sensor to the nozzle opening. To resolve this, calibrate the temperature.
What to do if the solder is not liquid with my TOOLCRAFT Rework stations?
If the solder is not liquid, it could be due to several reasons: * The temperature is too low. In this case, the heat is dissipated too quickly, especially when working on larger workpieces. Try reducing the distance between the nozzle and the workpiece. You can also set a higher temperature or use a nozzle with a smaller diameter. * The product may not be suitable for the soldering work, for example, soldering large workpieces. * The product is only designed for use with soft solders.
How to troubleshoot no display information on TOOLCRAFT Rework stations?
First, ensure that your TOOLCRAFT Rework station is properly connected to the mains and switched on. Also, check if the fuse has been triggered. If so, inspect the fuse and replace it if necessary.
Crucial safety guidelines for device usage by children and untrained individuals.
General safety rules, product handling, supervision, and contact information for queries.
Requirements for safe connection and use of the power cable and mains voltage.
Guidelines for selecting a safe and appropriate installation site for the rework station.
Safe operating practices, environmental considerations, and handling precautions.
Steps for connecting the rework station to the mains power supply.
Adjusting temperature and air volume settings for channels.
Proper use of the desoldering gun for removing solder.
Step-by-step guide to replacing the soldering tip on the desoldering gun.
Procedure for changing the soldering tips on the soldering tweezers.
Instructions for replacing the soldering tip on the soldering iron.
General| Temperature range | 100°C - 480°C |
|---|---|
| Operating voltage | 230 V |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Weight | 2.5 kg |
| Air flow rate | 24L/min |
| Product type | Rework station |
| Nozzle Size | 10 mm |
| Dimensions | 188 x 135 x 245 mm |
To Next Page