Need help?Do you have a question about the TOORX MSX50 and is the answer not in the manual?
Defines the minimum safe clearance zone around the equipment for access and emergency dismount.
Connects guide rods to the rear stabilizer and attaches the base frame.
Secures the front vertical frame and seat pad support to the base frame.
Installs weight stack cover brackets, rubber bumpers, and weight plates.
Places and secures the upper frame with bolts, brackets, and washers.
Attaches the front press frame and swivel pulley brackets using axles and nuts.
Secures the front support frame and seat pad adjustment support.
Attaches butterfly frames and the leg developer using axles, bolts, and washers.
Attaches handles and inserts leg press frame/adjustment with lock knobs.
Routes and secures upper cables and pulleys using bolts, washers, and nuts.
Attaches butterfly cables and pulleys to the frame using bolts, washers, and retainers.
Routes and secures lower cables and pulleys using bolts, bushings, and nuts.
Attaches the foot plate and secures weight stack covers with screws and washers.
Attaches seat, backrest, and arm curl pads, and installs foam roll tubes.
Attaches the short bar, gourd hook, and lat bar using chain, bolts, and washers.
To Next Page
General