Ex. 3 Rotary Angle
Stepper motor stepping is 5000, or servo motor 5000 pulse/round, reduction ratio is 1:30,
then,
5000*30 → 5
360*1000 → 12
3.3.2 Speed Parameters
Hsped-X: The highest speed of x axis motor. When the system is operating, speed will not
exceed this number no matter what F you set.
Hsped-Y: The highest speed of Y axis motor. When the system is operating, speed will not
exceed this number no matter what F you set.
Hsped-Z: The highest speed of Z axis motor. When the system is operating, speed will not
exceed this number no matter what F you set.
Hsped-C: The highest speed of C axis motor. When the system is operating, speed will not
exceed this number no matter what F you set.
StartSpd(mm/min)Speed during Speed+Time
Man Hspd：Manual high speed
Man Lspd
：
Manual low speed
Jog Spd: Jog speed
BZHSpd:Go to machine zero at high speed.
BZLSpd:Go back to machine zero first at high speed, through zero switch and move back at
low speed. Finally slider will stop on the switch.
BZMode:two modes to go back to machine zero, trough switch or not. Through switch: slider
will stop on switch. Not trough switch: Slider will stop before the switch.
X+ Coor:X axis positive limit coordinates
X-Coor:X axis negative limit coordinates
Y+ Coor:Y axis positive limit coordinates
Y-Coor:Y axis negative limit coordinates
Z+Coor:Z axis positive limit coordinates
Z-Coor:Z axis negative limit coordinates
C+Coor:C axis positive limit coordinates
C-Coor:C axis negative limit coordinates
To Next Page
Loading...
Need help?
General
