Dry: Press the key and it become negative display, then press Auto Run to start running
without load.
Step: Positive display means consecutive operation. Negative display means operate
command by command. When it is negative display, press Actl Run once, one command will
be executed.
Stop: Press this to end the program and go back to the first line of the command.
Speed: Negative display means manual high speed, positive display means manual low speed.
Define manual high speed and manual low speed in Parameters-Speed-Man Hspd/Lspd.
Jog: Negative display means jog. Press direction key to jog once. Jog amount is set in
Parameters-Control-Jog+No.; Jog speed will be set in Parameters-Speed-Jog Spd
Program Zero: Press this key all axis go back to reference point at highest speed. Define the
highest speed in Parameters-Speed.
Note: Machine Zero
Machine zero key is in the panel , press this key, then press direction key of an axis, this
axis will go back to machine zero at high speed, after touching the switch, this axis will move
at low speed(This machine zero mode is trough switch). Define high speed and low speed of
go back to machine zero in Parameters-Speed. Define machine zero in I/O-System.
Press key 1 to return X axis coordinates to reference point, Press key 3 to return Y axis
coordinates to reference point, Press key 3 to return Z axis coordinates to reference point,
Press key 6 to return C axis coordinates to reference point. Define reference point in
Parameters-Control.
Define the mode of going back to machine zero in Parameters-Speed-BZMode.
6. Installation Size
To Next Page
Loading...
Need help?
General
